Nortel TFC002 Manual page 55

Page 48 of 64 Implementation and operation
Prompt Response
REQ NEW, CHG
TYPE RDB
CUST xx
ROUT 0-511
TKTP RLM
...
ICOG ICT
ACOD nnnn
...
CNTL (NO) YES
- TIMR FLH
0-(512)-32000
ICF 0-(512)-32640
OGF
0-(512)-32640
ODT
256-(4096)-16128
553-2681-100 Standard 5.00
Note 1: When the CAS feature is defined, a signal Remote key is
assigned automatically to the key above LPK5 on all CAS Main
Attendant Consoles.
Note 2: For the M1250 and M2250 Attendant Consoles, the C/H key
acts as the CAS key.
LD 16 – Add or change a trunk route at a CAS Main location.
Description
Add, or change the CAS Main.
Route Data Block.
Customer Number.
Route Number.
Release Link Main trunk type.
Incoming trunk route.
Trunk access DN. This DN and the Route Member Number
display at the CAS Attendant Console. This DN cannot be
dial-accessed.
Changes to controls or timers.
CAS flash timer in ms. Recommended setting is 768 ms or
greater. The flash timer must be at least 256 ms shorter than
the outgoing flash timer (OGF) at the Remote end.
Incoming flash timer.
Outgoing flash timer.
Outgoing end-of-dialing timer for Digitone trunks.
August 1996