Table of Contents
Advertisement
General Troubleshooting continued...
Symptom
Solution(s)
Fixture is on but there
Make sure you have the correct audio mode on the control
is no movement to the
switches. If audio provided via ¼" jack, make sure a live
audio
audio signal exists
Adjust sound sensitivity knob
Fluid indicator not
The filter tip on the end of the tube inserted into the fluid
working
container must float freely in order to measure correctly,
check to see if perhaps it is stuck
Fogger or Snow output
Clean with distilled water and vinegar
has dropped
Replace hose
Lamps cuts off
Possible bad lamp or fixture is overheating.
sporadically
Lamp may be at end of its life.
Light will not come on
Some discharge lamps require a cooling off period before
after power failure
the electronics in the fixture can kick start it again, wait 5 to
10 minutes before powering up
Loss of signal
Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power cables or
black lights.
Motor movements are
Possible bad motor driver or sensors
jerky or jumpy
Check polarity switch on controller
Moves slow
Check 220/110v switch for proper setting
No flash
Re-install bulb, may have shifted in shipping
No fog
Check fluid tank if empty
Make sure green light is on (for power)
No laser output
Bounce mirror motor may have shifted during shipping,
readjust
No light output
Check slip ring & brushes for contact
Install bulb
Call service technician
Relay will not work
Check reset switch
Check cable connections
Remote does not work
Make sure connector is firmly connected to device
Stand alone mode
All Chauvet lighting fixtures featuring stand-alone functions
do not require additional settings, simply power the fixture
and it will automatically enter into this mode
Unit wobbles when
Check for damages possibly incurred during shipping
rotating
ST-200X User Manual
16
Appendix
Applies to
Foggers
Lights
& Snow
Controllers
Revision: 2004-11-02/11:00
Dimmers
& Chaser
Advertisement
Table of Contents
