SATO Argox O4-250 User Manual page 35

3 Printer operation
16. Speed
The speed of printing. The unit is inch per second (ips).
17. ABS. Darkness
The current darkness. You can use the PPLZ command ~SD to define it.
18. Trim. Darkness
The adjustment of the current darkness. You can use the PPLZ command
^MD to define it.
19. Print Method
It is either thermal transfer (TT) or direct thermal (DT) printing. TT requires
ribbons and DT doesn't.
20. Print Length
The total print length.
21. Cut Count
It counts the times the cutter cuts.
22. RS232 Protocol
It lists RS-232C settings in the following order: baud rate, data length, parity
check, stop bit and flow control.
23. Caret Control Char
The control character your printer is using.
24. Delimiter Control Char
The control character your printer is using.
25. Tilde Control Char
The control character your printer is using.
26. Code page
The character set table.
27. Media
The media type in use.
28. Calibration mode
There are intelli mode or smart mode.
Intelli mode: Just install labels, latch print module, press FEED button once,
and then the printer will feed 1-2 labels to detect next gap / black mark
before printing. The printer will feed 1-2 labels automatically before printing,
if FEED button is not pressed.
29