Table of Contents
Advertisement
Operating precautions
Do not use in the following locations
z
y Where flammable gases, etc. may leak
y Near the ocean or other areas with a lot of salt
y In areas where sulphurous gases occur such as natural spa
areas
y In places where there may be airborne water or oil (including
machinery lubricants, etc.) or steam
y Where there are large fluctuations in voltage
y Where machinery emitting electromagnetic waves are located
y Where there may be airborne organic solvents
Installation precautions
Do not install in locations with high humidity, lots of oil,
z
vibrations, where direct sunlight can reach the unit, or near
sources of heating
(This may cause malfunction)
Part names
(Left side)
Name
(1)
Colour LCD with touch panel
(2)
Power indicator
(3)
USB terminal
(4)
Storage door
(5)
LAN terminal
4
(5)
You can operate the unit by touching the screen with your fingers.
This lights when the power is on.
Connect a USB memory device here to backup data from this unit (settings, accumulation/distribution).
Open this cover to connect a USB memory device to the USB terminal.
To open, gently push on the storage door and then allow to drop down.
To close, lift the storage door and gently press closed.
Connect to a network with wiring.
Do not apply strong shocks
z
(This may cause malfunction)
Do not use heaters near the controller
z
(This may cause deformation or discolouration)
Do not use hard or pointy objects
z
(This may cause scratches or malfunction)
Do not hit the touch panel or push on it too strongly
z
(This may cause malfunction)
Do not install in noisy locations
z
(This may cause incorrect operation)
Install at least 4 ft. (1 m) away from TV, radio, PC. etc.
z
(To prevent fuzzy images or noise)
(1)
(The illustration shows the storage door open)
Explanation
(2)
(3)
(4)
Advertisement
Table of Contents
