Table of Contents
Advertisement
Basic settings on the indoor unit
6
Touch [Register].
To cancel the settings, touch [Cancel].
z
7
Put a check mark in the "Register"
column.
Select the indoor units you want to manage.
z
This procedure is not necessary if central addresses have
z
been automatically set. (→ "Automatically setting central
addresses" (P.18))
8
Touch [Register].
To cancel the settings, touch [Cancel].
z
Note
y Do not register indoor units in the same area to multiple distribution
groups.
18
6
7
8
Automatically setting central addresses
1
Put a check mark in the "Register"
column.
Select the indoor units you want to manage.
z
1
2
Touch [CNTR adr AutSet].
2
Note
y The central address is shared with other centralised
controllers (system controllers, etc.). Do not change unless
necessary.
y After setting the central address in the "Edit unit settings"
dialogue, and then enable [CNTR adr AutSet], the central
addresses will be overwritten.
Advertisement
Table of Contents
