Removing The Noise Filter Pcb And Inveter Pcb - LG LSE4617ST Service Manual

REMOVING THE NOISE FILTER PCB AND INVETER PCB

WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
CAUTION
• Be careful when you work on the
electric range handling the sheet
metal part.
- Sharp edge may be present and you can cut
yourself.
1. Turn off the electrical supply going to the range.
2. Pull the range away from the wall so that you can
access the rear panel.
3. Pull the controller from the range.(See page 3-4)
4. Pull the Cooktop from the range(See page 3-7)
5. Remove the ceramic glass cooktop(See page
3-8)
6. Remove the Working coil plate(See page 3-9,10)
7. To remove the NOISE FILTER PCB and
INVETER PCB
a) Unplug the 1 WARM Heater Connector.
COMPONENT ACCESS
Warm HTR Connector
b) Remove the 6 Screws from the PCB Case.
Screw 3EA
(Same as Right Side)
c) Remove the 4 Screws from the NOISE FILTER
PCB and INVERTER PCB.
(Same as Right Side)
- When you assemble the PCB,
Make sure the PCB Position after color-
check.
3-13
Left
Left
CAUTION
Left Right
(Blue) (Black)