Related Manuals for Theben TIMEGUARD UDSS2PIR
Summary of Contents for Theben TIMEGUARD UDSS2PIR
- Page 1 LED Ready PIR Up/Down Light Model: UDSS2PIR (Silver Finish) Model: UDB2PIR (Black Finish)
-
Page 2: General Information
1. General Information These instructions should be read carefully and retained for further reference and maintenance. Timeguard reserve the right to alter these instructions Note: at any time. Up to date instructions will always be available for download at www.timeguard.com 2. -
Page 3: Selecting A Location
• PIR Detection Range: 4 - 7m at a 2m mounting height (adjustable) • Dectection Angle: 90˚ (Fixed) • Time ON Adjustment: 10 seconds - 5 minutes • (LUX) level adjustment: 10 - 2000 • Manual Override: • Construction: Stainless steel •... -
Page 4: Installation
• Avoid positioning the luminaire near any sources of heat in and around the detection area such as extractor fans, tumble dryers or boiler exhauhsts etc. This would also include other light sources such as secuirty lights. • Reflective surfaces (i.e. pools of water, white painted walls, overhanging branches and other types of foliage) may cause false activation under heightened weather conditions. - Page 5 • Mark the position of the mouting holes on the wall using the wall plate as a template. • Drill the holes for the wall plugs ensuring not to infringe on any gas/water pipes or electrical cables that may be hidden below/behind the surface.
-
Page 6: Connection Diagram
• Replace the luminaire over the wall plate, ensuring the gasket is in place, and tighten the two nuts hand tight, to secure the fitting. 6.Connection Diagram • Connect the 230V AC 50Hz mains supply cable as follows; Isolation Switch Brown or Red Blue or Black Note that the earth terminal is attached directly to the fitting. - Page 7 7.Commisioning and Operation • Restore the power from the mains supply breaker or isolating switch and test for the correct operation. Walk Test Procedure • Adjust the time dial (fully anti-clockwise), and the Lux dial should be set to the minimum for daylight/night operation for the purpose of the walk test.
-
Page 8: Manual Override
appro.90° 1.5 - 2.0M Detection Area 8.Manual Override • The luminaire can be switched on for longer peroids via the use of the manual override mode. This can be activated by using the internal wall switch. Switch the internal wall switch once OFF/ON within 2 seconds. -
Page 9: Year Guarantee
Problem Cause/Solution False activation. Heat sources as described in section 4. (Luminaire switches Reflective surfaces described in section 4. on for no apparent Moving pedestrians, cars or animals in reason) the area. Check the detection area. Nearby electromagnetic disturbance from a neighbouring circuit (CCTV interference). - Page 10 If you experience problems, do not immediately return the unit to the store. Email the Timeguard Customer Helpline: HELPLINE helpline@timeguard.com or call the helpdesk on 020 8450 0515 Qualified Customer Support Coordinators will be online to assist in resolving your query. For a product brouchure please contact: Timeguard Limited.