Advertisement
GET THE POWER BOARD AND PUT
THE CABLE TO THE LOCATION WHICH
APPOINTED
CONNECT THE CABLE AND POWER
BOARD BY WHITE GLUE
MARK THE APPOINTED LOCATION AS
LEFT PICTURE SHOW
AFTER FINISHED ABOVE STEPS, PUT
THE POWER BOARD TO THE
PRODUCTION LINE
CONNECT THE MAIN BOARD AND
POWER BOARD AND PUT THEM IN TO
THE PCB SHIELDING
PUT THE SPRING TO THE DVI SINK OF
THE PCB SHIELDING
LOCKUP THE LOCATION OF POWER
BOARD BY A SCREW(M4*8-B) AS LEFT
PICTURE SHOW
LOCKUP THE LOCATION OF POWER
BOARD BY THREE SCREWS(F3*6-T)
AS LEFT PICTURE SHOW
Advertisement
