Honda EM10000K1 Manual page 34

dummyhead dummyhead
GENERATOR/CHARGING SYSTEM
Attach a chain hoist (1) to the engine hangers and pull
the chain tight to support the engine. Or place wooden
blocks under the front housing to support the generator/
engine assembly.
Remove the tapping screw.
Remove the washer-bolts and brush holder.
Remove the washer-bolts and terminal block.
Remove the washer-bolts and terminal block bracket.
Remove the bolts, nuts, rear housing and stator.
Installation is reverse order of removal.
• Route the harnesses properly (page 2-4, Base shop
manual: page 2-12).
TORQUE:
REAR HOUSING BOLT:
REAR HOUSING
MOUNTING NUT:
SH, SKH type shown:
REAR HOUSING
NUT (10 mm) (2)
34 N·m (3.5 kgf·m, 25 lbf·ft)
BOLT (6 x 45 mm)
8-10
20 N·m
(2.0 kgf·m, 15 lbf·ft)
34 N·m
(3.5 kgf·m, 25 lbf·ft)
STATOR COVER
BRUSH HOLDER
WASHER-BOLT
(6 x 15 mm) (2)
(1)
STATOR
REMOVAL/INSTALLATION:
·The stator is heavy. Take care
not to get injured during
installation/removal of the stator.
·Remove/install the stator by
winding a commercially available
lifting strap around the stator and
lifting it up as shown.
BOLT (8 x 170 mm) (4)
20 N·m (2.0 kgf·m, 15 lbf·ft)
STATOR
LIFTING STRAP
(Commercially available)
TAPPING SCREW
(5 x 14 mm)
WASHER-BOLT
(5 x 20 mm) (2)
TERMINAL BLOCK
WASHER-BOLT
(6 x 15 mm) (2)
TERMINAL BRACKET