Thermostat Other Features - Quadra-Fire TREKKERI-MBK Owner's Manual

COPY PROGRAM FEATURE:
Using similar instructions as
PROGRAMS
the COPY button will allow a whole day of
set program events to be copied to another day.
1. Move TEMPERATURE switch to HEAT as well as move
SET switch to TEMP PROG position.
2. Starting with Monday, use the UP or DOWN buttons to
adjust the start time and set temperature for the MORN,
DAY, EVE, and NITE events. Press the COPY button
and then press the NEXT button to advance to Tuesday.
3. With Tuesday displayed press COPY button. As
all programs events from Monday will be copied to
Tuesday (this will advance automatically to the next
day; Wednesday, as the word COPY will appear on the
screen for one second).
4. Continue in this pressing COPY button to set desired
days with original setting.
NOTE: The word COPY will not appear on the display
for Monday, but will display each day afterwards for
approximately one second and the day of the week will
automatically advance forward to the next day.
U. Thermostat Other Features
NOTE: All other features need to be completed in a timely
manner as the thermostat will time out after 10 seconds.
TEMPERATURE CALIBRATION:
The internal temperature sensor in this thermostat is
accurately calibrated at the factory, and in most cases
alterations to this setting should not be needed. The
temperature calibration feature allows you to manually offset
the measured temperature by as much as plus or minus 5°F
(3°C) from its original value. If several thermostats are used
in the same house, this feature can be used to synchronize
this thermostat to the others.
Change the temperature calibration:
1. Move TEMPERATURE switch to OFF.
2. Move SET switch to RUN.
3. Press and hold both UP and DOWN buttons together for
at least 5 seconds; the words SET and CAL will appear
on the display along with a single flashing temperature
digit.
4. Use the UP or DOWN buttons to change the number of
degrees desired for adjustment; 0° is the default value
and also means no correction will be applied.
5. Press the NEXT button to accept the setting.
16
SET TEMPERATURE
7082-803B
KEYPAD LOCKOUT:
There is the option to lock the front panel buttons to prevent
unauthorized tampering of your thermostat settings.
To Lock the Keypad:
1. Move TEMPERATURE switch to HEAT.
2. Move SET switch to RUN.
3. Perform a single press of each button in the following
sequence:
• NEXT, NEXT, NEXT, HOLD
A padlock will appear on the display screen.
To Unlock the Keypad:
1. Move TEMPERATURE switch to HEAT.
2. Move SET switch to RUN.
3. Perform a single press of each button in the following
sequence:
• NEXT, NEXT, NEXT, HOLD
A padlock will no longer be present on the display screen.
HARDWARE RESET:
The hardware reset button; labeled HW RST, is a small
round push button that is located in the middle of the circuit
board, just below the battery holder (Figure 16.1). Pressing
this button will:
• Cause the LCD display screen to become fully populated
• Thermostat to perform an internal system check of its
components
If the thermostat appears to be acting in an erratic manner,
pressing the HW RST button may remedy this behavior.
The temperature programs are not erased when a hardware
reset is performed, however the clock will have to be
changed to match the current day and time.
RST
Figure 16.1
HW
06/21