Advertisement
Mounting the Unit
1.
Water mains run behind walls near water
WARNING:
fixtures such as sinks and drains. Do not use
long screws when mounting system.
2. Use a stud finder to locate a suitable anchor point for the system.
3. If you cannot locate a stud, 4 drywall anchors with a 20 lb.
weight load capacity can be used. Multiple anchor points are
available to allow for varying mounting scenarios.
4. Use a level to make sure the system is vertical before securing
it to the wall.
Mounting the Inlet Bypass Manifold
1.
Water mains run behind walls near water
WARNING:
fixtures such as sinks and drains. Do not use
long screws when mounting system.
2. Before permanently mounting the water inlet bypass manifold,
locate the incoming water supply as well as the location of the
faucets. Pick a position that is conveniently located near the
water inlet and faucets to minimize necessary plumbing.
3. Secure the water inlet bypass manifold to the wall using the
appropriate mounting hardware (not included) to step 4.
4. Use a stud finder to locate a suitable anchor point for the water
inlet bypass manifold. If you cannot locate a stud, 4 drywall
anchors with a 30 lb weight load capacity can be used.
5. Use a level to make sure the water inlet bypass manifold is
mounted horizontally.
6. Once the bypass manifold is installed, plumb in the inlet water
supply and the run connections over to the faucets.
ACS-1 Inlet & Outlet - Figure 3
Water Inlet 1/2"
Pentair® Everpure® ActivTapp ACS-1 Installation and Operation Guide • 5
Water Outlet 1/2"
Advertisement
