Advertisement
Step 3:
Move the Speed Slider level to its minimum level.
Step 4:
You may now use the audio slider to adjust the music sen-
sitivity. The music sensitivity will automatically control either
the internal microphone or an audio input signal connect to
the rear of the controller.
Running a Chase Pattern with the Tap Sync:
This mode will allow to run your patterns to your deter-
mined speed rate. In this mode you manually enter a
speed rate by tapping on the Tap Sync Button. You can
use this function to create a constant rate to the beat of
the music by tapping the Tap Sync to the beat.
Step 1:
Be sure the Audio, Speed, and Fade Time Sliders are set to
lowest levels.
Step 2:
Select your desire chase patterns
Step 3:
Tap the Tap Sync Button at a regular rate. You will notice
that the chase pattern will begin to advance at the same
rate you were tapping.You will also notice that the Tap Sync
LED will flash at the same rate you were tapping on the Tap
Sync Button.
Step 4:
You can override this setting at any time by selecting the "Audio Function."
You may also clear this setting by raising the Speed Slider to it's maximum
level.
Running a Chase Pattern Using the Glide Function:
This mode will allow to run your patterns to a preset fade time. This gives
the effect of one scene fading in to the next. This function is used in con-
junction with any of the other three operating modes
Step 1:
American DJ Supply
www.americandj.com Stage Desk-16™ Instruction Manual Page 17
©
®
All manuals and user guides at all-guides.com
Operation Cont.
While in any of the other operating mod
Button. The Glide LED will begin to glow
function has been activated.
Step 2:
With the glide function activated press
Button that stores the chase you wish to
Step 3
If the chase is already running you mus
select it in order for the glide function to
Step 3:
To discontinue the glide effect, deselec
and deselect the Chase Pattern that is ru
Blackout Button.
Step 4
Kill Function:
This function allows you to remove sp
scene. You may take out as many chan
terns as you would like. Please note, A
a chase or scene, the channel's fader l
lit for a scene, or continue to flash for
Step 2
and serves as a reminder that channel i
chase. Be sure that although the chann
producing any output. To add a KILL:
Step 1:
Press the Kill Button to activate the Kill
Tap Sync
glow indicating Kill Mode has Been activ
Step 3
Step 2:
Press the Flash Buttons for the channe
chase pattern.
Step 3:
The channels you selected will now d
normal operation, tap the Kill Button onc
Add Function:
This function allow you to turn on more
same bank. Without this function you m
pattern as long as they are in different b
American DJ Supply
©
www.americandj.com Sta
®
Advertisement
