Advertisement
Controls & Functions Cont.
Manual or Blackout Buttons.
14. Audio Button -
This button will activate audio mode, which will sync a chase operation
with the beat of an audio source.
15. Tap Sync Button -
This button is used to manually establish a chase rate. The chase rate will
synchronize to rate you tap on the Tap Sync Button, tap the button twice
a second and the chase will advance two steps every second. Setting the
Tap Sync will override any previous chase rate settings.
16. Step Button -
This button gives you manual control over any running chase. Pressing
this button will advance the chase pattern one step. This function will work
in conjunction with the audio and tap sync functions, so be sure to lower
the audio sensitivity and turn off the tap sync function to have full control
over the chase patterns. This will also activate the lock function when
combined with the BLACKOUT BUTTON.
17. Dark Button -
This button provides a temporary black out function. When you hold down
this button all channel output will cease, until the button is released.
Please note that any chase running will continue to run in the back
ground, so a chase may not be at the same step as it was when the DARK
button was initially pressed.
18. Full On Button-
Holding this button down will momentarily bring all 16 channels to full
output. This function will only work as long as the button is held down. This
function will function under any operating mode.
19. Blackout Button -
This button functions as a blackout and is also used to clear any current
operating mode. Holding this button down for over a second will bypass
the fade function. This will also activate the lock function when combined
with the STEP BUTTON.
20. Audio Level Slider -
This button controls the amount of audio sensitivity a chase will react to
when the "Audio" function is selected.
American DJ Supply
www.americandj.com Stage Desk-16™ Instruction Manual Page 9
©
®
All manuals and user guides at all-guides.com
Controls &
1. Channel LED's -
These 16 LED's display the current inten
2. Channel Sliders -
These 16 serve two functions: 1) They
They activate the programmed assigned
3. Flash Buttons -
These 16 buttons serve two functions: 1
are used to record it's respective chan
mode these button are used to turn on a
4. Pattern LED -
These 16 LEDs indicate channel activity
tons.
5.Pattern Buttons -
The 16 pattern buttons activate the use
patterns. You may program a static sce
these 16 pattern banks.
6. Built-in Pattern LEDs -
These green LEDs indicate activity of th
Rear Panel:
33
34
21. Speed Slider -
This slider controls the speed a chase w
22. Fade Time Slider -
This slider adjust the initial fade time fo
Fade time will increase as the slider is p
maximum possible fade time. Fade time
American DJ Supply
www.americandj.com Sta
©
®
Advertisement
