Connect The Scanner - Canon CanoScan 9950F Quick Start Manual

Connect the Scanner

1
Connect the FAU cable to the scanner.
2
Connect the scanner to the computer with the supplied USB interface cable.
Supplied USB Interface Cable
FAU Cable
Wide Flat Connector
USB Interface Cable
• On a Macintosh, you cannot have the USB cable and the IEEE1394 interface cable connected
to the scanner at the same time.
• To use the scanner with an IEEE 1394 (Fire Wire) port on a Macintosh computer, please
purchase the IEEE 1394a (Fire Wire 400) cable recommended by Canon.
• Please read the IEEE1394 caution sheet bundled with the scanner for precautions with the
IEEE1394 interface and cables recommended by Canon.
3
Attach the supplied AC adapter to the scanner.
4
Press the power switch on the scanner's
front panel to turn the power on.
The Scan Lamp will light.
• Only use the USB interface cable and the AC adapter provided with the scanner. Use of
other cables or adapters may lead to a malfunction.
• When the scanner is connected to the USB 1.1 port on Windows XP, do not worry if the
"HI-SPEED USB Device Plugged into non-HI-SPEED USB Hub" message appears. You can
operate the scanner in this condition without problems.
FAU Connector
Small Square Connector
AC Adapter
IEEE1394 (FireWire) Interface Cable
(Macintosh only)
FAU Cable
IEEE1394
Interface
Cable
Power Switch
Connect the Scanner
IEEE1394 Connector
7