Needle And Presser Foot Section; Right-Side/Rear View - Brother Computerized Embroidery Sewing Machine Operation Manual

Needle and presser foot section

1
7
6
5
a Buttonhole lever
Lower the buttonhole lever when sewing buttonholes
and bar tacks.
b Needle bar thread hooks
Pass the upper thread through the needle bar thread
hooks.
c Needle plate
The needle plate is marked with guides for sewing
straight seams.
d Bobbin cover/Shuttle
Remove the bobbin cover, and then insert the bobbin
into the shuttle.
e Feed dogs
The feed dogs feed the fabric in the sewing direction.
f Presser foot
The presser foot applies pressure consistently on the
fabric as the sewing takes place. Attach the appropriate
presser foot for the selected stitching.
g Presser foot holder
The presser foot is installed onto the presser foot holder.

Right-side/rear view

2
3
4
a Handle
b Balance wheel
c Embroidery card slot
d Main power switch
e Power supply jack
f Foot controller jack
g Air vent
h Feed dog position switch
2
3
4
5
Carry the sewing machine by its handle when
transporting the machine.
Turn the balance wheel toward you to raise and lower
the needle to sew one stitch.
Insert the embroidery card.
Use the main power switch to turn the sewing machine
on and off.
Insert the plug on the power supply cord into the power
supply jack.
Insert the plug on the end of the foot controller cable
into the foot controller jack.
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the sewing
machine is being used.
Use the feed dog position switch to lower the feed dogs.
Memo
Refer to Cover B, C, D or E pages while you
are learning to use your machine.
1
8
7
6
Cover C