Cleaning Primary Air Filter Element; Evacuator Valve; Air Cleaner With Dust Cup - Kubota GL7000-CAN Operator's Manual

24 PERIODIC SERVICE
(1) Air cleaner body
(2) Cover
(3) Secondary element
(4) Primary element
BCleaning Primary Air Filter Element
1. To clean the element, use clean dry compressed air on
the inside of the element.
Air pressure at the nozzle must not exceed 205 kPa
(2.1 kgf/ , 30 psi).
Maintain reasonable distance between the nozzle and
filter.
2. To wash the elements, use Donaldson ND-1500 Filter
Cleaner, or its equivalent, which is especially effective
on oily and soot-laden filters. Follow instructions that
are supplied with the filter cleaner.

(5) Evacuator valve

(6) Hooking clip
(7) Air cleaner
BEvacuator Valve
Open the evacuator valve once a week under ordinary
conditions - or daily when used in dusty condition - to get
rid of large particles of dust and dirt.
A If the dust cup is mounted incorrectly, dust or dirt will
not collect in the cup and allow the dust to come into
direct contact with the element and thus require the
element be replaced prematurely.
(1) Air cleaner body
(2) Secondary element
(3) Primary element
(4) Dust cup
(5) "TOP" mark
(6) Evacuator valve
BAir Cleaner with Dust Cup
Remove and clean out the dust cup once a week under
normal conditions or daily in extreme conditions.
Do not allow the dust cup to fill above half way regardless
of conditions.
Install the air cleaner dust cup with "TOP" indicated on the
rear of the cup in the upward position with horizontally
mounted air cleaner bodies or vertically mounted air
cleaner bodies, the cup may be mounted in any direction.