Kubota GL7000-CAN Operator's Manual page 10

KEEP THE AREA AROUND THE ENGINE CLEAN
A Be sure to stop the engine before cleaning.
A Keep the engine clean and free of accumulated dirt, grease and trash
to avoid a fire. Store flammable fluids away from sparks and fire.
A DO NOT stop the engine without idling. Sudden stops can cause
temperatures around the engine to rise suddenly. Keep the engine
idling for about 5 minutes before stopping.
SAFE HANDLING OF FUEL AND LUBRICANTS
A Always stop the engine before refueling and/or lubricating.
A DO NOT smoke or allow flames or sparks in the working area.
Fuel is extremely flammable and explosive under certain conditions.
A Refuel only when the engine has cooled off. Refuel in a well
ventilated and open place. When fuel and lubricants are spilled, clean
them up before starting the engine.
A DO NOT mix gasoline or alcohol with diesel fuel. The mixture can
cause a fire and damage engine components.
A Operate the generator on a firm and level surface only.
DO NOT tilt or move the generator while it is running since this can
cause fuel spillage.
EXHAUST GASES & FIRE PREVENTION
A Engine exhaust fumes can be very harmful if allowing them to
accumulate. Be sure to run the engine in a well ventilated place and
where there are no people or livestock near the generator.
A DO NOT operate the generator in a closed area such as inside
houses, warehouses, tunnels, wells, ship holds, tanks, etc. or places
without proper ventilation.
A DO NOT operate the generator where the building or other
obstructions block off air circulation or where exhaust gas can
accumulate.
A The exhaust gas from the muffler is very hot. To prevent a fire, DO
NOT expose to dry grass, papers, oil and any other combustible
materials to exhaust gas. Also, keep the engine and muffler clean at
all times.
A To avoid fire, be alert for leaks of flammables from hoses and lines.
Be sure to check for leaks from hoses or pipes, such as fuel and
engine oil by following the maintenance check list.
A To avoid a fire, DO NOT short across power cables and wires. Check
to see that all power cables and wiring are in good condition.
A Keep all power connections clean and tight. Bare wire or frayed
insulation can cause a dangerous electrical shock and personal
injury.
SAFE OPERATION
-
3