Canon BJC-S630 Quick Start Manual page 34

Troubleshooting
Problem
Printer is not
responding
(continued)
Printer tried
to print but
no ink on
paper
Troubleshooting Printed Output
Problem
Printed
colors are
incorrect
28
Possible Cause
Bad cable Replace the printer cable.
Computer and/or Reboot the computer and/or reset the printer.
printer needs to
1. To reboot the computer, close all open applications, then restart.
be reset
2. To reset the printer, turn it off, then on again.
Ink tanks are not Check the ink tanks, and reseat them if necessary. See "Replacing Ink
seated properly Tanks" on page 20.
Printhead Verify that the printhead is working properly. See "Printing a Nozzle
clogged Check Pattern" on page 20. or "Cleaning the Printhead" on page 22.
If necessary, perform multiple printhead cleanings. See the S630
User's Guide on the Setup Software & User's Guide CD-ROM for more
information.
Ink tanks may Verify that you have sufficient ink in the ink tanks. See "Monitoring
need to be Ink Levels" on page 19.
replaced
If necessary, replace the ink tanks. See "Replacing Ink Tanks" on
page 20.
Printhead may Verify that the printhead is working properly. See "Printing a Nozzle
need to be Check Pattern" on page 20 or "Cleaning the Printhead" on page 22.
replaced
If necessary, perform multiple printhead cleanings. See "Cleaning the
Printhead" on page 22 or the S630 User's Guide on the Setup
Software & User's Guide CD-ROM for more information.
Possible Cause
One or more ink Verify that each ink tank is lined up with the correct color label in the
tanks installed in printhead. For more information, see "Replacing Ink Tanks" on page 20.
the wrong
If ink tanks were placed in the incorrect color slots in the printhead,
position
after switching the tanks to their correct slots, perform at least two
printhead cleanings to remove the incorrect residual colors from the
printhead. For procedures, see "Cleaning the Printhead" on page 22.
Incorrect Color
Adjustment
setting
Try This
Try This
WINDOWS
On the Main tab of the S630 Properties window, confirm that
Color Adjustment is set to Auto.
If Manual is set, click the Defaults button on the Manual Color
Adjustment window.