Service Menu 6 - Sensor Test - Husqvarna VIKING Designer Jade 20 Service Manual

Service Program Jade 35

Service Menu 6 - Sensor test

Entering service menu 6.
With pressing the stitch selection button 5 and Mirror button, turn on the power switch.
Service program "Sensor test" will start.
First digit of 7 segment LED will indicate the sensor condition as follows.
a
g
f
b
e
d
c
h
a. Stop sensor
b. Timing sensor
c. Stop sensor
Checks the sensors of the synchronizer. The LED are turned on and off while the hand wheel
is turned around slowly in the direction of sewing.
d. One step buttonhole switch (rear)
e. One step buttonhole switch (front)
Lower the buttonhole lever and push or pull. The LED will be turned on and off.
f. Not used this machine
g. Bobbin winder switch
By turning the bobbin winder spindle left or right, LED will be turned on and off.
h. Presser foot lifter switch
If the presser foot lifter is lowered, LED will be turned on.
1047356-26 33