European Community, Switzerland, Norway, Iceland, And Liechtenstein - Cisco Catalyst IR1800 Series Installation Manual

Rugged router hardware
Hide thumbs Also See for Catalyst IR1800 Series:
Table of Contents

Advertisement

Regulatory Compliance
This device has been designed to operate with antennas having a maximum gain of 8 dBi. Antennas having a
gain greater than 8 dBi are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotopically radiated power (EIRP) is not more than that permitted for successful communication.
Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems.
Users are advised that high-power radars are allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN
devices.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
European Community, Switzerland, Norway, Iceland, and
Liechtenstein
Cisco
Declaration of Conformity with Regard to R-ED Directive 2014/53/EU
The following standards are applied:
The conformity assessment procedure referred to in Article 10.4 and Annex III of Directive 2014/53/EU has
been followed.
Note
This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain
frequencies or may require a license for operation or both. For more details, contact the Cisco Corporate
Compliance team.
The product carries the CE mark:
®
Catalyst IR1800 Rugged Series Router PIDS.
IR1821
IR1831
IR1833
IR1835
ETSI EN 301 489-1 V2.2.3; EN 301 489 - 17 v3.2.4
Draft ETSI EN 301 489-19 V2.2.0 (2020-09)
Draft ETSI EN 301 489-52 V1.1.2
Health & Safety-EN 62368-1; EN 50835:2017
Radio-EN 300 328 v2.2.2; EN 301 893 v 2.1.1 , EN 62311:2019

European Community, Switzerland, Norway, Iceland, and Liechtenstein

Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
81

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst ir1821Catalyst ir1831Catalyst ir1833Catalyst ir1835Catalyst ir1800 rugged series

Table of Contents