Cisco Catalyst IR1800 Series Installation Manual page 16

Safety Warnings
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available . Statement 1024
Warning
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV) requirements
in IEC 62368 and IEC 60950 based safety standards. Statement 1033
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Warning Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact
with such circuits, because they may cause serious injury or death. For proper installation and grounding of
the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National Electrical Code,
Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the covers
installed. Statement 1077
Warning Hot surface. Statement 1079
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
8
Preface