Attaching Module To Enclosure Door; Figure 4: Installing The D9133Ttl-E On The; Mounting Plate; Figure 6: D9133Ttl-E Mounted In Panel - Bosch D9133TTL-E Installation Manual

D9133TTL-E | Installation Guide | 3.0
Figure 4: Installing the D9133TTL-E on the

Mounting Plate

Detail A
1
8
5
7
6
1 - Top plastic standoffs
2 - Top mounting brackets
3 - Bottom mounting brackets
4 - Bottom plastic standoffs
5 - Bottom mounting holes
6 - Bottom screws
7 - Top Screws
8 - D9133TTL-E Module
To attach the mounting plate to the module:
1. Insert the top hook of the top and bottom plastic
standoffs into the mounting brackets on the
mounting plate. Refer to Detail A on Figure 4.
2. Insert two of the screws into the top two plastic
standoffs and secure to the top mounting plate
brackets by tightening the screws.
3. Place the top edge of the D9133TTL-E module
under the facing hook (refer to Detail A) on the
plastic standoffs.
4. Align the bottom two mounting holes with the
bottom two mounting brackets.
5. Insert two of the screws through the bottom
module mounting holes, through the bottom
standoffs, and into the bottom mounting
brackets. Slowly tighten them down until the
D9133TTL-E is seated securely to the mounting
plate.
6
Installation
2
4
5
3.1.2

Attaching Module to Enclosure Door

When the module is securely attached to the
mounting plate (refer to Figure 4), slide the tabs at the
top of the mounting plate over the top lip of the
enclosure door (refer to Figure 5), then slide the
mounting plate to the outer edge of the enclosure
door (refer to Figure 6).
Figure 5: Attaching Module to Enclosure Door
3
1 - Tabs
2 - Top lip of enclosure door
Figure 6: D9133TTL-E mounted in Panel

Enclosure

1
6
1 - Mounting plate
2 - D9133TTL-E Network Interface Module
3 - Bosch control panel
4 - Battery
5 - Non-power limited area
6 - Enclosure Door
Non-power limited area - All power limited
wiring must remain out of this area.
Bosch Security Systems, Inc. | 6/07 | 4998122717-01
2
1
2
3
5
4