Table of Contents
Advertisement
2.1.2
Attaching the Module to the Enclosure Door
When the module is securely attached to the mounting
plate (refer to Section 2.1.1 Using the Optional Mounting
Plate on page 6), attach the module to the enclosure
door. Refer to Figure 3.
1. Slide the tabs (1) at the top of the mounting plate
over the top lip of the enclosure door (4).
2. Position the mounting plate closest to the edge
opposite the door hinge.
Figure 3:
Attaching the Enclosure Door
4
3
1 - Tab
2
Mounting plate
Position the mounting plate along the top
edge of the enclosure door away from the
hinged edge.
Bosch Security Systems, Inc. | 5/07 | 4998122718-02
1
2
3
Enclosure door
4
Top lip
C900TTL-E | Installation Guide | 2.0
2.1.3
Mounting in a Separate Enclosure
The C900TTL-E can be mounted in a separate
enclosure like the AE2. Refer to Figure 4.
Mount the enclosure on a vertical surface
before installing the module. One of the
mounting holes (A) is covered after the
module is installed.
1. Place the top edge of the C900TTL-E module (1)
between the two slots (8) on the inside top of the
enclosure (7).
2. Insert the top hook of the top plastic standoffs (4)
into the mounting brackets (6) on the back wall of
the enclosure. Item 5 in Figure 4 shows a side view
of the standoff in the mounting bracket.
3. Align the bottom two mounting holes (3) on the
C900TTL-E with the plastic standoffs (4) and the
enclosure mounting brackets (6).
4. Insert two screws (2) into the holes and slowly
tighten them until the C900TTL-E is attached
securely to the enclosure.
Figure 4:
C900TTL-E in AE2 Enclosure
1
8
7
1 - C900TTL-E module
2
Screws
3
Bottom mounting
holes
4 - Top plastic
standoffs
Installation
2
3
4
5
6
5
Standoff in
mounting bracket
6 - Mounting brackets
(side view)
7 - Enclosure
8 - Slots
.
7
Advertisement
Table of Contents
