Brother P-Touch 9500pc Quick Reference page 22

3 Check the tape cassette.
Make sure that the end of the tape is not
bent and that it is routed correctly through
the tape guides.
End of the tape
Install the tape cassette.
4
Be sure to install the tape cassette in the
correct direction.
Close the tape compartment cover.
5
Tape guides
6 Press the power button on the
PT-9500PC.
→ The power button will light (green).
• If the tape compartment cover is not
completely closed or if the tape cassette
is not installed correctly, the ERROR
lamp will light. In this case, repeat the
procedure from step
Press the feed/cut button.
7
→ Remove the tape slack.
Note
●
If no additional operation is performed
within 10 minutes after printing a label,
the roller holder will automatically
release and a sound may be produced.
Due to this function, the tape cannot be
removed if the AC adapter is removed
from the PT-9500PC with the PT-9500PC
turned on because the roller holder will
not be released. Always turn off the
PT-9500PC before removing the AC
adapter from the PT-9500PC.
Power button
2
.
Feed/cut button
21