Advertisement
Quick Links
The NFKx-LAUNCH launch fibers are used with the OF-500 OptiFiber
OTDR tests. Using a launch fiber lets the tester measure the loss of the first
connector in the cabling. You may also use a NFKx-LAUNCH fiber as a receive fiber.
Using a receive fiber lets the tester measure the loss of the last connector in the
cabling.
A launch fiber comes with the following:
•
Instruction sheet
•
Warranty registration card
Launch Fiber Models and Specifications
Model
NFK1-LAUNCH
NFK2-LAUNCH
NFK3-LAUNCH
NFK1-LAUNCH-ST
NFK2-LAUNCH-ST
NFK3-LAUNCH-ST
PN 1997795 September 2002, Rev. 2, 6/06
© 2002, 2003, 2006 Fluke Corporation. All rights reserved. Printed in USA.
All product names are trademarks of their respective companies.
Provided by www.AAATesters.com
Zipper Color
62.5/125 μm multimode launch fiber, 100 m,
Gray
SC/SC connectors with UPC polish
50/125 μm multimode launch fiber, 100 m,
Aqua
SC/SC connectors with UPC polish
9/125 μm singlemode launch fiber, 130 m,
Yellow
SC/SC connectors with UPC polish
62.5/125 μm multimode launch fiber, 100 m,
Gray
SC/ST connectors with UPC polish
50/125 μm multimode launch fiber, 100 m,
Aqua
SC/ST connectors with UPC polish
9/125 μm singlemode launch fiber, 130 m,
Yellow
SC/ST connectors with UPC polish
NFKx-LAUNCH
Launch Fiber
Instruction Sheet
™
tester during
Specifications
-continued-
Advertisement
Related Manuals for Fluke NFK-LAUNCH Series
Summary of Contents for Fluke NFK-LAUNCH Series
- Page 1 9/125 μm singlemode launch fiber, 130 m, NFK3-LAUNCH-ST Yellow SC/ST connectors with UPC polish -continued- PN 1997795 September 2002, Rev. 2, 6/06 © 2002, 2003, 2006 Fluke Corporation. All rights reserved. Printed in USA. All product names are trademarks of their respective companies.
- Page 2 Launch Fiber Models and Specifications (cont.) Model Zipper Color Specifications 62.5/125 μm multimode launch fiber, 100 m, NFK1-LAUNCH-LC Gray SC/LC connectors with UPC polish 50/125 μm multimode launch fiber, 100 m, NFK2-LAUNCH-LC Aqua SC/LC connectors with UPC polish 9/125 μm singlemode launch fiber, 130 m, NFK3-LAUNCH-LC Yellow SC/LC connectors with UPC polish...
- Page 3 Pre-moistened swabs or wipes approved for use on fiber connectors ™ Use a fiber microscope, such as the Fluke Networks OFTM-5352 FiberInspector Video Probe, to inspect fiber endfaces for damage. If a launch fiber endface is damaged, you should replace the launch fiber as it may cause unreliable test results.
- Page 4 Resellers are not authorized to extend any other warranty on Fluke Networks’ behalf. To obtain service during the warranty period, contact your nearest Fluke Networks authorized service center to obtain return authorization information, then send your defective product to that Service Center with a description of the problem.