Attaching Top Hinge Bracket; Attaching Slide-Housing To Refrigerator Door - Westinghouse IK009 Installation Manual

ATTACHING THE TOP HINGE
BRACKET
. 1 Remove top hinge cover (Figure 3), cover
clips o .
2. Remove the three (3) top hinge screws.
3. Elevate hinge.
. 4 Slide the top hinge bracket into position
below the hinge.
. 5 Re-attach hinge and screws ensuring that
refrigerator door is still correctly positioned.
IMPORTANT!
You must ensure that the refrigerator door is:
• Parallel with sides and top of cabinet.
•
The gap between the door and cabinet is
typically 10mm allowing the door gasket to
act correctly (Figure 4).
NOTE: Ensure the gasket acts correctly, i.e. doesn't
make a noise or leave gaps when the door is closed.
6. Recap hinge cover into position.
Figure 3
1
Top hinge cover
2
3
Top hinge bracket fitted.
Figure 4
6
5
Top hinge
bracket
5
4
10mm
ATTACHING SLIDE-HOUSING TO
REFRIGERATOR DOORS
. 1 Ensure slide-housing is positioned squarely
as shown.
. 2 Ensure that the slide-housing is positioned
on the door as shown in the diagrams.
Slide housing (Flat Door version)
100mm
door
handle
Slide housing (Curve Door version)
NOTE: The slide-housing 'wider edge' side must always
be closest to the door handle side.
wider edge
100mm
door handle
slide housing (flat)
slide housing (curve)
9