Westinghouse IK009 Installation Manual page 6

6 westinghouse.com.au
DIMENSIONS (CONTINUED)
Clearances
When installed the
refrigerator needs to have
adequate air ventilation. It is
important to ensure there
is good airflow from the
front to underneath and up
the rear to the top of the
cabinet (see diagrams).
Front airflow cut-out
NOTE: A decorative grill can be fitted so long as it does
not obstruct airflow and is removable for cleaning.
Dim E
Bottom rear airflow cut-out
Top rear airflow cut-out
80mm
50mm
Dim E
300mm
Dim E
When positioned in a corner the clearance of Dim G on
the hinge side of the cabinet will allow the doors to be
opened enough to enable the removal of the crisper bins.
Dim C
120º
NOTE: Use the 120° hinges supplied with the kit to attach
the cupboard door to the cupboard.
Attach the hinge to the door to ensure that door can have
maximum opening, i.e. the door edge should not hit the
cabinet when the door is fully open.
Cabinet construction
(top mount cupboard shown below)
NOTE: If Dim D is larger than 1000mm in height, 3 hinges
are required to attach the cupboard door to the cupboard.
If Dim D is smaller than 1000mm in height, 2 hinges are
required/sufficient.
Dim G
Dim I
5mm gap
between doors
Dim D