Attaching The Rear Rollers - Westinghouse IK009 Installation Manual

8 westinghouse.com.au
INSTALLATION (CONTINUED)

ATTACHING THE REAR ROLLERS

A set of adjustable back feet/rollers is provided in the kit.
These are required to ensure that the product is levelled
correctly, failure to fit these may result in the poor operation
of door opening.
. 1
Temporarily unfasten the screws holding the
compressor base plate.
. 2
Fit the assembly with the removed screw and
one from the kit (item 11).
3. Repeat for the other side.
Once fitted turn the adjusting nut on each roller assembly
anti-clockwise three full turns, this will raise the cabinet
at the rear by approximately 12mm (ensure that the nut is
completely wound up before turning).
Then secure the nut and roller assembly in place with tape
(this will prevent the roller assembly from falling out when
the refrigerator is place in the cupboard).
Stand the refrigerator upright. On a horizontal and flat floor
adjust the rollers until the refrigerator is vertical and does
not rock.