Ethernet (Wired Network Only) - Brother Network MFC-7840W Network User's Manual

IPv6
This machine is compatible with IPv6, the next generation internet protocol. If you want to use the IPv6
protocol, choose On. The default setting for IPv6 is Off. For more information on the IPv6 protocol, visit
http://solutions.brother.com.
a
Press Menu.
b
Press a or b to choose LAN.
Press OK.
c
(For Wired) Press a or b to choose Wired.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d
Press a or b to choose TCP/IP.
Press OK.
e
Press a or b to choose IPv6.
Press OK.
f
Press a or b to choose On or Off.
Press OK.
g
Press Stop/Exit.
Note
After you choose IPv6 On, this setting will be applied to both the wired and wireless LAN interface.

Ethernet (wired network only)

Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been
reset (default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a
Press Menu.
b
Press a or b to choose LAN.
Press OK.
c
Press a or b to choose Wired.
Press OK.
d
Press a or b to choose Ethernet.
Press OK.
Control panel setup
6
6
6
81