Configuring Your Machine For A Wireless Network; Using The Setup Wizard From The Control Panel - Brother Network MFC-7840W Network User's Manual

Configuring your machine for a wireless network

IMPORTANT
• If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation. You must know your wireless network settings before you
proceed with this installation.
• If you have previously configured the wireless settings of the machine, you must reset the network LAN
settings before you can configure the wireless settings again. Press Menu, 5, 0 for Factory Reset,
Reset and choose Yes to accept the change. The machine will restart automatically.

Using the Setup Wizard from the control panel

You can configure your Brother machine by using the Setup Wizard function. This is located in the LAN
menu on the machine's control panel. See to the steps below for further information.
a
Write down the wireless network settings of your access point or wireless router.
SSID (Service Set ID or Network name)
WEP key (if needed)
WPA-PSK password (if needed)
WPA-PSK encryption (TKIP or AES)
LEAP user name (if needed)
LEAP password
b
Plug the machine's power cord into the AC power outlet. Turn on the machine's power switch.
c
Press Menu on the control panel of the Brother machine.
d
Press a or b to choose LAN.
Press OK.
Select ab or OK
5.LAN
e
Press a or b to choose WLAN.
Press OK.
LAN
2.WLAN
f
Press a or b to choose Setup Wizard.
Press OK.
WLAN
2.Setup Wizard
Configuring your machine for a wireless network
3
3
3
29