Wps W/Pin Code (Wireless Network Only); Wlan Status (Wireless Network Only); Ethernet (Wired Network Only); Mac Address - Brother MFC-J4310DW Network User's Manual

Control panel setup

WPS w/PIN Code (wireless network only)

If your WLAN access point/router supports Wi-Fi Protected Setup (PIN Method), you can configure the
machine easily without a computer. (See Configuration using the PIN Method of WPS (Wi-Fi Protected
Setup) on page 16.)

WLAN Status (wireless network only)

Status
This field displays the current wireless network status.
Signal
This field displays the current wireless network signal strength.
SSID
This field displays the current wireless network SSID. The display shows up to 32 characters of the SSID
name.
Comm.Mode
This field displays the current wireless network communication mode.

Ethernet (wired network only)

The Ethernet link mode, Auto, allows the print server to operate in 100BASE-TX full or half duplex, or in
10BASE-T full or half duplex mode by auto negotiation.
NOTE
If you set this value incorrectly, you may not be able to communicate with your print server.

MAC Address

The MAC address is a unique number assigned for the machine's network interface. You can check your
machine's MAC address from the control panel.

E-mail / IFAX (For MFC models) (Available when IFAX is downloaded)

These settings have six selections: Mail Address, Setup Server, Setup Mail RX, Setup Mail TX,
Setup Relay and Manual POP3 Receive. As this section requires you to enter a lot of text characters,
you may find that it is more convenient to use Web Based Management and your favorite web browser (see
Web Based Management on page 46). The settings must be configured for the IFAX feature to work. (For
more details about Internet fax, see Internet fax (For MFC models) (Available as a download) on page 59.)
4
4
4
4
4
4
4
4
4
4
34