Ethernet (For Wired Network Only) - Brother MFC 685CW - Color Inkjet - All-in-One User Manual

c
Press a or b to select WLAN.
Press OK.
d
Press a or b to select WLAN Status.
Press OK.
e
Press a or b to select Comm. Mode.
Press OK.
f
The current wireless network communication mode will be displayed; Ad-hoc or Infrastructure.
g
Press Stop/Exit.
Ethernet
(for wired network only)
Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT
full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been
reset (default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a
Press Menu.
b
Press a or b to select LAN.
Press OK.
c
Press a or b to select Wired LAN.
Press OK.
d
Press a or b to select Ethernet.
Press OK.
e
Press d or c to select Auto/100B-FD/100B-HD/10B-FD/10B-HD.
Press OK.
f
Press Stop/Exit.
Control panel setup
6
6
92