Symbols Used; Explaining The Signal Alert Symbol On The Device; Intended Use - Bosch rexroth IndraControl XFE 01.1 Operating Instructions Manual

IndraControl XFE 01.1 Extension Mod-
ules Profibus, RT-Ethernet, Sercos, CAN
CAUTION
In case of non-compliance with this safety instruction, minor or moderate injury
can occur.
NOTICE
In case of non-compliance with this safety instruction, material damage can
occur.

3.3 Symbols used

Pointers are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.

3.4 Explaining the signal alert symbol on the device

krax

4 Intended use

NOTICE
The IndraControl extension modules may exclusively be used with the
accessories and
Components that are not expressly mentioned must neither be attached nor
connected. The same applies to cables and lines.
Only to be operated with the component configurations and combinations
expressly defined and with the software and firmware specified in the
corresponding functional description.
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
Risk of damaging the device if not expressly
stated accessories, mounting parts and other
components, cables, lines and software and
firmware are used.
add-on components specified in this
R911345570_Edition 05 Bosch Rexroth AG
5/31
Intended use
documentation.