Electric Installation; External Power Supply Unit - Bosch rexroth IndraControl XFE 01.1 Operating Instructions Manual

18/31
Mounting, demounting and electric installationI
and disengage the control (see (A) in the following figure). The base
latches are locked in the open position.
3. Remove the extension module vertically to the mounting rail (see (B) in the
following figure). The base latches engage again in idle position.
Fig. 10-6: Removing extension module from top-hat rail

10.5 Electric installation

WARNING
Any dangerous system states, which might cause personal injury, must be
●
prevented!
Protection upon direct and indirect contact must be ensured by the specified
●
measures (connection to protective conductor, insulation, etc.).

10.5.1 External power supply unit

All control components are supplied from 24 V voltage supplies.
Use the Bosch Rexroth power supply unit VAP01.1H-W23-024-010-NN, part
number R911171065, for the logic supply. For further information on the
external power supply unit and on the creation of overvoltage categories, refer
to the documentation of the power supply unit.
Bosch Rexroth AG R911345570_Edition 05
A
Danger of personal injury due to incorrect
mounting or electric installation!
IndraControl XFE 01.1 Extension Mod-
ules Profibus, RT-Ethernet, Sercos, CAN
A
B