Table of Contents
Advertisement
All manuals and user guides at all-guides.com
38
advanced features
programme satellite receiver Enter the details of the programme into your satellite
receiver (see receiver manual) and put a tape in the VCR.
set tape speed Press / on the Remote Control to set the tape speed to either
or
.
SP
LP
engage vcr in auto mode Press and hold
SAT
c on the VCR for about 2 seconds. The
SAT
c
indicator on the VCR display panel lights up and the VCR turns off automatically. Any signal
detected at the
connecter will automatically start the VCR recording; when the
L-2 IN/DECODER
signal stops, so will the VCR.
Notes
connectors Auto Satellite Prog Recording is only possible using the
L-2 IN/DECODER
connec-
tor.
timer mode You cannot put the VCR into
when using Auto Satellite Prog
TIMER MODE
Recording Mode.
r The number of programmes recorded will not be displayed on the VCR display
panel when the r button is pressed.
timer recording Auto Satellite Prog Recording is not possible if your satellite receiver does
not have a timer.
indicator The
c indicator light flashes when Auto Satellite Prog Recording is in progress.
SAT
disengage To disengage the VCR during Auto Satellite Prog Recording, press the o button.
The VCR will stop recording and turns off.
tape speed When recording two or more programmes consecutively, you cannot set a different
tape speed for each programme. The first speed selected will apply to all programmes in that
recording session.
b.e.s.t. The
system will not work during Auto Satellite Prog Recording.
B.E.S.T.
does not work when in Auto Satellite Prog Recording mode.
Just Clock
just clock
incoming signal The VCR will only react to the start of an incoming signal at the
L-2 IN/
DECODER
connecter. If you try to engage Auto Satellite Prog Recording Mode whilst the satellite
receiver is powered on, the
c indicator light will flash but the VCR will not record. You must
SAT
power the satellite receiver off then on again to begin recording in these circumstances.
cable input You can record in the same way from a cable system as long as you connect the
cable system has a timer on/off function and is connected to the
.
L-2 IN/DECODER connector
incompatibilities Some satellite receivers output signals even when turned off. These receiv-
ers cannot be used with this VCR in this way.
Advertisement
Chapters
Table of Contents
