Power-Up Diagnostics; Home Key - Toro Network VP 4.00 Satellite User Manual

Power-Up Diagnostics

Upon power-up, the satellite will display:
Network VP
Booting
The Network VP Satellite will initiate a diagnostic test automatically during power-up. This function will take
approximately ten seconds and it can not be bypassed. If a problem is detected during the diagnostic test, it will be
indicated on the display. These status information can not be edited. The information is as follows:
Line 1: Network VP Firmware Version and Revision Date
Line 2: Detect: [xx stations, yy sensors] (xx = number of stations detected, yy = number of sensors detected)
Line 3: Last Power Downtime Date and Time
Example:
Rev: 4.00 09/15/10
Detect: 64sta, 00sen
PD - 09/16/10
The default Home display will follow after the diagnostic display has timed-out.
Home display example:
Sun 04/02/06 02:31 pm
Sat# 001-001 Sec: 57
Day Change: 12:00am

Home Key

Pressing the Home Key will revert to the default display. When editing irrigation programs, Station or Satellite
settings, pressing the Home Key will save any setting modifications and return the user to the Home display.
Home display examples:
Sun 04/02/06 02:31 pm (Typical Home display with no active scheduled program)
Sat# 001-001 Sec: 57
Next start: 03:00am
Sun 04/02/06 02:31 pm
Sat# 001-001 Sec: 57
Running 02 programs
P01 Sta01 00:09:46
P05 Sta25 00:19:51
The Day Change line will display the next program start time (Next Start: HH:MM) if the current day is
an active watering day. If the satellite is running a program, the Day Change line will display Running XX
programs to indicate the number of active programs.
8
(Home display with two active scheduled programs)
(Use the down arrow button to access hidden display lines on the screen)