Whirlpool 7MWFC9822HC Use And Care Manual page 29

All-in-one washer and dryer

Hide thumbs

Table Of Contents

Table of Contents

Available languages

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.whirlpool.mx/owners

If you experience

Error Code Appears in Display

Once any possible issues are corrected, touch the POWER button once to clear the code. Re-select and restart the cycle.

F0E1

Load detected

in Clean Washer

with affresh

cycle

F0E2

Oversuds detection

F0E5 (OB)

Off-balance load

detected

F1E1

ACU memory corruption or

hardware failure/ACU main

relay cannot be opened or

closed

F1E2

MCU memory corruption

or hardware failure

F3E1

Analog pressure failure

F3E2

Wash NTC failure

F3E5

Dry NTC failure

F3E6

Accelerometer failure

F4E1

Water heater relay failure

F4E2

Wash heater relay circuit

fault

F4E4

Fan drive failure

F5E1

Door switch failure

for assistance and to possibly avoid a service call.

Possible Causes

Items detected in the washer/dryer

when running a Clean Washer with

affresh

cycle.

Excessive suds in washer/dryer.

Washer/dryer is running a suds

reduction routine. Allow the wash

cycle to continue.

Load could be unbalanced or too

large.

Problem detected with the washer/

dryer.

Problem detected with the washer/

dryer.

Problem detected with the pressure

sensor.

Open circuit or short circuit fault

detected.

Open circuit or short circuit fault

detected. The wash function is still

operable, but the dry function will

not operate.

Accelerometer failed self text or

experienced orientation error.

Problem detected with the water

heater. There is a water heater relay

short error or feedback failure.

Wash heater relay is detected as not

closed.

Dry fan triac open circuit, short circuit,

diode mode, or feedback KO fault

detected.

Problem detected with the door

switch. Door is unlocked during a

cycle when it should be locked.

Solution

Remove load and restart the Clean Washer with affresh

Use only HE detergent. Always measure detergent, following

manufacturer's directions based on your load requirements.

Increase concentration level of Load & Go Dispenser through

the Tools button.

Run Rinse & Spin cycle without detergent to remove excess

suds.

Make sure the Load & Go bulk dispenser is disabled if you are

using a single dose of detergent.

Avoid tightly packing the washer/dryer. Avoid washing single

items. Balance a single item with such as a rug or jeans with

a few extra items.

Reboot the washer/dryer by touching and holding the 'Home'

icon for 15-20 seconds. If the problem persists, try resetting

the washer/dryer by unplugging it from the outlet and then