Table of Contents
Advertisement
4
Barracuda 4FC Installation Guide, Rev. A
drive when the drive is mounted in an equipment rack
or cabinet. When units are stacked vertically, pay spe-
cial attention to the top where temperatures are usu-
ally highest.
•
Follow the precautions listed above in "Electrostatic
discharge protection."
•
Do not remove any circuit boards from the drive chas-
sis. Return the entire drive for depot repair if any cir-
cuit board is defective. Removal of circuit boards by
personnel not performing depot repair will damage
components and may void the warranty.
As a component, the drive is designed to be installed and
operated in accordance with UL1950, IEC950, CSA C22.2
950-M89, and VDE0805 and EN60950.
Seagate takes all reasonable steps to ensure that its
products are certifiable to currently accepted standards.
Typical applications of these disc drives include customer
packaging and subsystem design. Safety agencies condi-
tionally certify component assemblies, such as the Barra-
cuda disc drive, based on their final acceptability in the
end-use product. The subsystem designers are responsi-
ble for meeting these conditions of acceptability in obtain-
ing safety-regulatory agency compliance in their end-use
products and for certifying where required by law. A nec-
essary part of meeting safety requirements is the provi-
sion for overcurrent protection on drive SELV supply
voltages.
Advertisement
Table of Contents
