Package Contents - Stanley STPP7502 Original Instructions Manual

Cable cross-sectional
area (mm )
2
0.75
1.00
1.50
2.50
4.00
Voltage Amperes
110-127 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
220-240 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear safety glasses or goggles.
Wear ear protection.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
Cable rated current
(Ampere)
6
10
15
20
25
Cable length (m)
7.5 15 25 30 45
Cable rated current (Ampere)
6 6 6 6
6 6 6 6
6 6 10 15
10 10 15 20
15 15 20 25
20 20 25 -
6 6 6 6
6 6 6 6
6 6 6 6
10 10 10 10
15 15 15 15
20 20 20 20
Direct Current
n No-Load Speed
0
Class II Construction
Earthing Terminal
Safety Alert Symbol
Revolutions or
/min. Reciprocation per
minute
Position of date code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:

PACKAGE CONTENTS

1 Planer
2 TCT blades
1 Parallel fence
1 Wrench
1 Dust bag
60
1 Vac adaptor
1 Instruction Manual
• Check for damage to the tool, parts or accessories which
6 10
may have occurred during transport.
• Take the time to thoroughly read and understand this
15 15
manual prior to operation.
20 20
FEATURES (Fig. A)
20 25
This tool includes some or all of the following features.
25 -
1. On/off switch
2. Lock-off button
- -
3. Shavings discharge outlet
6 6
4. Shavings discharge outlet selector
5. Planing depth adjustment knob
6 6
6. Planing depth graduation
10 15
ASSEMBLY
15 15
WARNING! Before assembly, make sure that the
20 20 tool is switched off and unplugged.
Replacing the cutting blades (Fig. B)
25 -
The cutting blades provided with this tool are reversible.
Replacement cutting blades can be obtained from your local
retailer.
NOTE: The STPP7502 has two blades, one on each side of
the blade drum. Any operation or adjustment should be made
to both blades.
Removing
• Loosen the bolts (7) using the spanner supplied.
• Slide the blade (8) out of the holder.
• Reverse the blade so that the unused side comes in
position. If both sides are worn, the blade must be
replaced.
Fitting
• Slide the blade into the holder until it is against the end
stop.
• Tighten the bolts using the spanner supplied.
WARNING! Always replace both cutters.
Adjusting the depth of cut (Fig. C)
The depth of cut is indicated by the marking (9). The setting
range can be read from the graduation (6).
• Turn the planing depth adjustment knob (5) to the required
depth of cut.
(Original instructions)
2017 XX JN
Year of manufacturing
ENGLISH
7