4.8
Binding the evotouch controller to the DT92 room adjuster/sensor
4.8.1
Binding procedure
f
Follow the guided or expert configuration until the
following screen appears.
evotouch controller as close as possible
f
Position the
to the DT92.
f
Press and hold both arrows up and down until the
display changes.
f
Press button (1).
Binding takes place automatically.
i
Press button (1) approx. 5 sec. when the display on
DT92 does not appear as pictures shows.
i
The binding mode remains active for max. 10 minutes
after the last button was pressed.
40
1
evotouch