Deactivating the RF communication check
f
Remove and re-insert the batteries of the DT92.
or
f
Disconnect the power supply.
or
f
Press the bind button.
Completing configuration
f
Press the DONE button.
Configuration of the HCW82 / HCF82 is completed.
4.10
Binding the evotouch controller to the HB85 temperature sensor
4.10.1
Binding procedure
i
To check whether the radio connection is ready for later operation, during binding the temperature sensor module
should remain as near as possible to the mounting site.
f
Follow the guided or expert configuration until the
following screen appears.
f
Press the bind button (1) on the HB85.
Binding takes place automatically.
i
Binding is terminated automatically after 4 minutes.
i
After successful binding, the HB85 transmits the
measured data to the evotouch controller at intervals
of approx. 10 minutes.
44
evotouch