Sensor Recharge Kit - Hach LANGE ORBISPHERE C1100 User Manual

Introduction

3.1.3 Sensor recharge kit

A recharge kit (as illustrated in
this will be required to initially make the sensor operational. It is also required for sensor
cleaning and membrane replacement procedures.
Note: The recharge kit for ozone has a green sticker on the front of the box.
The kit contains:
• four recharge cartridges with pre-mounted membrane and electrolyte. The type of
membrane mounted in the cartridge will be specific to the kit ordered
• anode cleaning tools
• a set of five cotton washers
• a set of replacement O-rings
• a set of replacement Dacron
The black anode cleaning tool
that may have formed. It is doubled-ended so it can be used for two membrane replacement
processes, each end being used once.
The cotton washers provide additional protection against the formation of deposits and residue
on the center electrode and anode, which prolongs the time period required between sensor
maintenance.
The Dacron
12
Figure 4
Figure 4 Sensor recharge kit
®
mesh patches
Figure 5 Anode cleaning tool
(Figure
®
mesh patches provide protection to the membrane.
below) should have been ordered with the sensor as
5) is used to clean the anode of any deposits or residue