Cleaning And Maintenance; Troubleshooting; Warranty - Dometic ACE AIR PRO 400 Operating Manual

Inflatable awnings
Hide thumbs Also See for ACE AIR PRO 400:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
8. Wait until most of the air has been expelled.
9. Remove the four corner pegs.
10. Fold/roll the awning tent towards the valves to expel more air.
11. When deflated, roll the awning tent to fit into the carry bag.
12. Ensure that all parts are clean before packing them into the carry bag.
13. If the awning tent is wet or damp, dry fully as soon as possible.

Cleaning and maintenance

A
NOTICE! Material damage
Do not use sharp or hard objects or cleaning agents for
cleaning.
Do not use alcohol based materials, chemicals, soap
and detergents for cleaning.
Remove bird droppings and tree resin as soon as
possible to avoid permanent damage to the material.
1. If necessary, clean the product with clean water and a soft brush.
2. Apply impregnation against water and UV radiation before each trip.
Storing the awning tent
I
NOTE
Fully set up the awning tent for cleaning.
Choose a sunny day for cleaning to ensure the material
will dry thoroughly.
1. Clean the awning tent.
2. Air fully and ensure the awning tent is totally dry before packing away.
3. Store in a well ventilated dry place.

Troubleshooting

I
NOTE
During first exposure to water there may be some
moisture at the seams. Through this moisture the threads
will swell and fill the holes that are created in the sewing
process.
A fully equipped spare parts kit should include:
waterproofer
repair tape and repair solution
silicone spray for the zippers
spare pegs
Problem
Solution
➤ Check that the valve is fully screwed into the air
Awning tent only inflates
with difficulties
➤ Check if the inflation tube is twisted at the
➤ Check that the hand pump is working.
➤ Check that all isolation valves that connect the
Part of the awning tent
does not inflate
➤ Check that all isolation valves that connect the
Part of the awning tent
does not deflate
➤ Add more air (9 psi/0.62 bar).
Air poles are kinked
➤ Check that the valve is fully screwed into the air
Air leak
➤ Check that the cap of the valve is done up
➤ Check for punctures, see chapter "Repairing a
12
pole.
valve.This may be indicated by noise. Untwist
the inflation tube.
air poles are open.
air poles are open.
pole and the ring seal is in place.
tightly.
puncture in the air pole" on page 12.
Problem
Water leak
Rip in the fabric
Condensation
All awning tents suffer from internal condensation if one or more of the
following conditions apply:
high air humidity
high ground moisture
a drop in temperature
Severe condensation can run down the inside of the roof and drip off ties,
tapes and other internal fittings and can be mistaken for leaking.
➤ Increase ventilation by opening doors and/or windows.
➤ Install a waterproof groundsheet.
Repairing a puncture in the air pole
If the air pole loses air, proceed as follows:
1. Unzip the outer sleeve holding the air pole.
2. If installed, close isolation valves.
3. Remove the air pole.
4. Deflate the air pole.
5. Unzip the protective sleeve to expose the inflatable tube.
6. Blow some air into the inflatable tube.
7. Submerge the tube in water.
8. Locate the puncture.
9. Use repair tape and repair solution to seal the hole.
10. Zip the inflatable tube back into the protective sleeve.
11. Zip the air pole back into the outer sleeve.
Disposal
➤ Place the packaging material in the appropriate recycling waste bins,
wherever possible.
If you wish to finally dispose of the product, ask your local recy-
M
cling center or specialist dealer for details about how to do
this in accordance with the applicable disposal regulations.

Warranty

The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see
dometic.com/dealer) or your retailer.
For repair and warranty processing, please include the following docu-
ments when you send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
The warranty covers manufacturing defects, materials and parts. The
warranty does not cover fading of the cover and wear and tear due to
UV radiation, misuse, accidental damage, storm damage, or permanent,
semi-permanent* or commercial use. It does not cover any resulting
damage. Please contact your dealer for claims. This does not affect your
statutory rights.
* All-Season models have been designed for use on seasonal pitches.
4445103255
Solution
➤ Check for leaky seams, damaged tapings and
moist areas.
➤ If you cannot find any leaks, see chapter "Con-
densation" on page 12.
➤ If you find any leaks, apply seam sealant.
➤ Use repair tape to seal the fabric.
➤ Have repairs carried out by an authorized
specialist.
EN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents