Step 6 Selecting The Next Operation - Brother E-100 Operation Manual

MAKING AN EMBROIDERED APPLIQUÉ FROM A ONE-POINT PATTERN
G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G
When the machine is finished
7
embroidering, it automatically stops and
the screen shown at the right appears.
Remove the thread cartridge.
8
The design frame moves back to its starting point
so it can be removed. After the final animation is
displayed, the screen shown at the right appears.
Key information
• To skip the animation, press any key.
Pull out the design frame. Then, take the
9
pre-cut design fabric out of the frame.
CAUTION
• Be sure to follow the correct procedure for removing the thread cartridge before
removing the design frame, otherwise the stitching may be damaged. (See the section
Removing the thread cartridge on page 15 and Removing the design frame on page 17.)
G G
6. Selecting the next operation
To embroider the same pattern again
Press the
page 13 under Inserting the thread cartridge and design frame appears. Repeat the steps to
embroider the same pattern.
To save the pattern
Press the
see the section Saving a pattern on page 34.
To embroider a different pattern
Press the
page 11 under Selecting the pattern appears. Repeat the steps to embroider a different pattern.
To finish using the machine
Press the
20
key until is highlighted, and then press the
or key until is highlighted, and then press the
key until is highlighted, and then press the
key.
Finished embroidery
key. The screen shown on
key. For more details,
key. The screen shown on