Reviewing The Tracer 5045 Rear Panel Design - ADTRAN TRACER 5045 System Manual

TRACER 5045 System Manual
For these LEDs... This color light...
Green (solid)
PWR
Off
TST Amber (solid)
Green
LAN (1–4)
Amber (blinks with activity)
Green
WAN
Amber (blinks with activity)
Green (solid)
PLAN A
Off
Green (solid)
PLAN B
Off
RF LOW Red (solid)
RF DOWN Red (solid)
4.

REVIEWING THE TRACER 5045 REAR PANEL DESIGN

Figure 2 identifies the various features of the TRACER 5045 rear panel and Table 1 on page 26 provides a
brief description of each interface.
A
RS232 Interface
(VT100 Terminal)
1
LNK
B
Test
Interfaces
612805045L1-1A
Table 2. TRACER 5045 LEDs
2 3 4
ACT LNK ACT LNK ACT LNK ACT
10/100 BASE - T/ TX
C
Alarm
Ethernet
Contacts
Figure 2. TRACER 5045 Rear Panel
© 2003 ADTRAN, Inc.
Indicates that...
the TRACER 5045 is connected to a power source.
the TRACER 5045 is not currently powered up.
there is an active test being performed by the system.
there is a valid 10/100BaseT/TX link.
there is data activity (transmit or receive data) on the
10/100BaseT/TX LAN interface.
there is a valid wireless link.
there is data activity (transmit or receive data) over the wireless
link.
the TRACER 5045 is transmitting on Frequency Plan A.
the TRACER 5045 is not transmitting on Frequency Plan A.
the TRACER 5045 is transmitting on Frequency Plan B.
the TRACER 5045 is not transmitting on Frequency Plan B.
the RSSI level is below suggested minimum threshold
(approximately 10 dBm above the minimum receive sensitivity).
there is a communication problem between the local and remote
TRACER 5045 systems.
E
DC Power
Connection
F
D
Fuse
Section 3 Engineering Guidelines
G
Antenna
Connector
Ground
H
Lug
27