IKEA LAGAN Manual page 13

ENGLISH
When the prescribed quantity of water (see
values in the table) has been used since the
previous regeneration process, a new
regeneration process will be initiated
between the final rinse and the programme
end.
Water softener level Amount of water (l)
1
2
3
4
5
6
7
8
9
10
In case of the high water softener setting, it
may occur also in the middle of the
programme, before the rinse (twice during a
programme). Regeneration initiation has no
impact on the cycle duration, unless it occurs
in the middle of a programme or at the end
of a programme with a short drying phase.
In that cases, the regeneration prolongs the
total duration of a programme by additional
5 minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin in
the same cycle or at the beginning of the
next programme. This activity increases the
total water consumption of a programme by
additional 4 litres and the total energy
consumption of a programme by additional
2 Wh. The rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible
more than one in the same cycle) may
prolong the programme duration by another
5 minutes when it occurs at any point at the
beginning or in the middle of a programme.
250
100
62
47
The rinse aid empty notification
25
The rinse aid helps to dry the dishes without
17
streaks and stains. It is automatically
released during the hot rinse phase.
10
When the rinse aid chamber is empty, the
5
rinse aid indicator is turned on notifying to
refill rinse aid. If the drying results are
3
satisfactory while using multi-tablets only, it
3
is possible to deactivate the notification for
refilling rinse aid. However, for best drying
performance, always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
End sound
You can activate an acoustic signal that
sounds when the programme is completed.
AutoOpen
AutoOpen improves the drying results with
less energy consumption. The appliance
door opens automatically during the drying
phase and remains ajar.
All the consumption values
mentioned in this section are
determined in accordance with
the currently applicable standard
in laboratory conditions with
water hardness 2.5mmol/L
according to the 2019/2022
regulation (water softener: level
3).
The pressure and the
temperature of water as well as
the variations of the mains supply
can change the values.
Acoustic signals sound also when
a malfunction of the appliance
occurs. It is not possible to
deactivate these signals.
13