Char-Broil COMMERCIAL Series Quick Start Manual page 8

15. Unscrew the ignitor cap located on the control panel and
remove the contact and spring from the ignitor slot.
See Fig. 7.
16. Place the supplied AA battery into the ignitor slot with the
positive pole facing toward you.
17. Place the spring with contact over the battery. Screw the
ignitor cap back onto the control panel.
FIGURE 7
Ignitor
–
cap
+
Contact Spring AA Battery
18. Place the 3 flame tamers on the lower ledge above
burners. See Fig. 8. They should meet in the center.
19. Place the cooking grids or griddle on the ledge above the
flame tamers.
20. Place the secondary cooking rack into the slots on the
upper left and upper right of the grill bowl panels.
FIGURE 8
Griddle
Flame tamer
Lower
ledge
21. Attach panel to front of left shelf by placing top lip of panel
ABOVE bottom lip of shelf. Secure using three 3/16"x3/8"
Phillips­head screws and 3/16" nuts. Fully Tighten.
See Fig. 9.
8 • 466231103
FIGURE 9
Shelf
lip
Before Your First Cookout
• Perform the leak test as indicated in the use and care
section.
• Wash the cooking grids, griddle, cooking rack, and all
stainless steel surfaces with warm, soapy water. Rinse and
dry thoroughly.
• Light burners. Check to make sure they are lit, then close
the lid and warm the grill on HI for 15 minutes. Curing of
paint and parts will produce an odor only on first lighting.
Secondary
cooking
rack
Cooking
grid
Panel lip