ADTRAN TRACER 4106 Plan A System Manual page 52

Section 5 User Interface Guide
>T1 S /C
X TATUS ONFIGURATION
Configures the T1 for the appropriate line buildout, based on the distance to the T1 equipment. By default,
the line buildout for the TRACER 4106/4206 is
>T1 S /C
X TATUS ONFIGURATION
Determines whether the TRACER 4106/4206 unit will report active alarms. If set to
be displayed on this menu page. The
and remote TRACER 4106/4206 units. When set to
(OFF). By default, alarm reporting is set to
>T1 S /C
X TATUS ONFIGURATION
Configures the framing format for the T1 link for both the local and remote TRACER 4106/4206 units. The
TRACER 4106/4206 transports T1 data across the link (as long as the T1 signal is properly timed). Configure
the framing format (using the
framing error events and indicate problems with the attached metallic service. The TRACER 4106/4206
supports both extended superframe (
method is set to ESF .
>T1 S /C
X TATUS ONFIGURATION
Sets the line coding for the T1 link. The TRACER 4106/4206 supports bipolar eight-zero substitution (
and alternate mark inversion (
>T1 S /C
X TATUS ONFIGURATION
Controls the loop status of the T1 link. Activates/deactivates loopback conditions for testing purposes.
>T1 S /C
X TATUS ONFIGURATION
Defines the T1 link as normal data transport mode - there are no active loopbacks.
>T1 S /C
X TATUS ONFIGURATION
Activates a loopback at the local TRACER 4106/4206 T1 framer towards the remote end of the wireless link
(see Figure 9). Use the local
across the radio link to the remote end of the link. This loopback tests the integrity of the radio link and all the
associated digital and RF hardware.
52
/L > T1
OOPBACK
0 dB/133
/L > A
OOPBACK
A R
LARM EPORTING
E
NABLED
/L > S
OOPBACK
menu) to enable the TRACER 4106/4206 to monitor incoming
S
IGNALING
ESF ) and superframe (
/L > L
OOPBACK
AMI ) line coding. By default, the line code is set to
/L > L
OOPBACK
/L > L
OOPBACK
/L > L
OOPBACK
loopback to loop the data transmitted from the remote end of the link back
L
INK
Figure 9. T1 Local Link Loopback
© 2004 ADTRAN, Inc.
TRACER 4106/4206 System Manual
L B O
X INE UILD UT
.
FT
R
LARM EPORTING
parameter is independently configured for the local
, the front panel LED alarms are also disabled
D
ISABLED
.
IGNALING
D4 ) framing formats. By default, the signaling
C
INE ODE
/N S
OOP ORMAL TATE
/N S
OOP ORMAL TATE
/N S
OOP ORMAL TATE
, no alarms will
D
ISABLED
B8ZS .
> N
ORMAL
> L [L ]
INK OCAL
612804206L2-1A
B8ZS)