Advertisement
Notes
When another pen is selected, the display shows the selected pen
with the number after "SIZE' or "GRAY."
Whichever resolution, 300 or 600 dpi, you have selected, the pen
size takes effect in units of 300 dpi.
Character Set
When you select "CHARACTER SET," you can select the standard and
alternate character sets used in the HP-GL emulation mode.
Enter the sub-setting menu and select the menu for the standard or
alternate character set with the
To set the standard character set, select the following message:
STANDARD SET
or
To set the alternate character set, select the following message:
ALTERNATE SET
Then press the SET switch to show the following message:
ANSI ASCII
Change the character set with the
selection effective by pressing the SET switch. For specific character
sets, see "SYMBOL/CHARACTER SETS" in Appendix.
or
switch:
*
or
switch and make the
CHAPTER 4 CONTROL PANEL
4–25
Advertisement
