Motorola MTM5 00 Series Basic Service Manual page 65

Maintenance
NOTE:
3. Remove the two connector clips on the antenna connector and power connector. A tool can
be used to remove the clips, if required.
4. Remove the GPS cable connector from the transceiver board.
CAUTION: Do NOT disconnect the GPS cable connector by jerking or pulling the cable;
!
instead disconnect by pulling the connector-head from the transceiver board.
5. Open the dust cover situated on the left side of the terminal. If a SIM card is present, push it to
dislodge and remove the SIM card.
NOTE:
6. Pull out the plastic accessory connector housing from the back of the terminal.
CAUTION: Do NOT use excessive force or twist the plastic accessory connector housing, as
!
this may damage the connector pins.
Diecast
Cover
Terminal
Chassis
Figure 6-5 Diecast Cover Removal
The diecast cover may be difficult to remove due to the main seal adhesion, if the
diecast cover has not been removed for a long time. The dismantling tool (Motorola
part number 6686119B01) can be used as a lever to pry and remove the diecast
cover.
Figure 6-6 Open Dust Cover
The SIM card must be removed before the transceiver board is removed to prevent
damage to the SIM card and connector.
Screws (7x)
6 - 9